Cut-wire shot is produced by cutting wire into lengths equal to the wire diameter. Quality is assured by control of the chemical and physical properties inherent in the wire and accurate sizing to length. Every piece is 100% solid. Cut-wire shot is available in an “As-Cut” (cylindrical) form as well as in a normal conditioned and special conditioned (Spherical) shape.
Cut wire shot is available in sizes from 0.40mm to 2.00mm .Today Company is providing the largest range of cut wire shot in different sizes and metals , which suits the best for its customer requirements . Details of product are given as below :
Grit Size Cast Steel Shot Size Cut Wire Shot (in inches) Equivalent Cut Wire Shot
G-50 S-170 0.017 0.40
G-40 S-190 0.020 0.50
G-40 S-230 0.023 0.60
G-25 S-280 0.028 0.70
G-25 S-330 0.032 0.80
G-18 S-360 0.035 0.90
G-18 S-390 0.041 1.00
G-16 S-460 0.047 1.20
G-17 S-550 0.054 1.40
G-12 S-660 0.062 1.60
G-10 S-780 0.080 2.00
MILD STEEL TYPE 1020
CARBON STEEL TYPE 1070
STAINLESS STEEL TYPE 302 / 304 /202 / 430
MILD STEEL 20 HRC
CARBON STEEL 45 - 54 / 55 - 60 HRC
302 / 304 / 202 / 430
32 HRC MINIMUM
SHAPE DESCRIPTION SPECIFICATION
AS CUT (-U) CYLINDRICAL WITH SHARP EDGE IS 5873-1970 / SAE J441
NORMAL (-C) CORNER PRE ROUND IS 5873-1970 / SAE J441
CONDITIONED (-3C) ALMOST SPHERICAL IS 5873-1970 / SAE J441
PACKING PROVIDED : 25Kgs. /Bag
Application of Cut Wire Shot
Blast cleaning of die-casting, foundry pieces, forgings, sand removal, steel board, steel material, H type steel structure.
Rust removal of foundry pieces, forgings, steel board, steel material, steel structure, descaling of forging.
Shot peening of heat treatment pieces, gear etc.
Shot blasting of profile steel, steel board, steel material, ship board.
Shot polishing of steel board, steel material, and profile steel.
Pre-treatment of surface, steel structure, before-painting.
ADVANTAGES OF CUT WIRE SHOT
1. Most economical and lowest consumption.
2. Available in various sizes as per requirement.
3. More life span, till completely reduced to smallest tiny particle.
4. Increases the fatigue life of the blasted components.
5. No possibility for dust formation during shot blasting.
6. Cleans the product faster.
7. Cuts down the maintenance cost of shot blasting machine.
8. No dust or health hazard during operation.
205 A , anmol tower , Indore, M.P.